Windows 10 reset pc not working12/24/2022 You can remove debris/dust from the system with a small PC vacuum and/or compressed air. Clean the memory contacts with isopropyl alcohol and be sure they are fully dry before reinserting into the memory slots. One last thing before it comes to that though, make sure the contacts on the memory are clean and that there is not excessive debris/dust in or around the memory slots. In searching Dell Error Code: 2000-0122, it appears that if the memory is replaced and the system still blue screens, it is likely that the memory slots themselves are faulty and a system board replacement would be the next option to fix it. If it hits blue screen again, you are likely dealing with a faulty system board. If the machine continues to blue screen with the memory in that slot, shut it down and move the replacement memory to Channel B DIMM 0 and boot again. Alternatively, you could remove all of the old memory and only insert the one single replacement stick into Channel A DIMM 0. Be sure you have replaced the correct bad memory stick (Channel B, DIMM 0) which you should be able to determine by the slot designations printed on the system board. It has two DIMM channels on the bottom access panel. Anyone have any ideas. I see from the service tag that this is a Dell Precision 7510 laptop. It has new memory in it and I have to use the external DVD drive to perform the recovery so everything I have found on line doesn't help to fix the problem. If you’re having trouble resetting your system, try the fixes. Windows 10 has a built-in option to reset the PC but this option can fail. I began the recovery process and it gets to 92% and throws up an error that says Bad Pool header. If the OS becomes too unstable, you get one too many BSODs, or it’s been infected to a point where it cannot be saved, the nuclear option is to reset the system. So after a lot of trail and error I decided on recovering the PC with the recovery disk. However the start menu and other programs did not run. I replaced it and it appears to booted up correctly. The laptop should boot from the USB and show the same WRE menu options as mentioned above.Well I got the new memory in and they only sent me one stick to replace. If you cannot boot from the USB you’ll need to get into BIOS (press F2 after it starts but before it boots into Windows - I think) and enable Legacy USB or CSM whichever option you have. You’ll need to change the boot order in BIOS to boot from the USB as the first option (press F10 after it starts but before it boots into Windows - I think). Once you have the USB drive insert it into your laptop and start the laptop. In the host PC go to Control Panel > Recovery > Create a Recovery drive and follow the prompts. (try another PC not yours)Īll you need is a 8GB USB flashdrive and about an hour of your time. The recovery USB disc can be created from any known working Win 10 PC. If you can’t get into the WRE menus this way or it doesn’t work either, try using a recovery USB disc. Once there select Reset this PC and select the option you want and follow the prompts. On the 3rd attempt it should boot into the Windows Recovery Environment menu area. start > boot > force shutdown > start > boot > force shutdown etc. Start the laptop and when it boots into Windows, force stop the laptop by holding the Power button until it shuts down.ĭo this 3 times in a row, i.e.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |